![]() ![]() Work Led > Turn on or off the LED light in the work area.Cam Led > Turn on or off the LED fill light for the camera.TouchSig > Test touch signal (Touch function will be disabled for a few seconds).Backlight > Test screen’s backlight (Screen will go black for a few seconds).Ventilator > Enable or disable the ventilation fan.Pump > Enable or disable the water pump.You will have to perform homing again in order to use the control panel above. If this is disabled you can move the laser head freely by hand, but the control panel above will be disabled. Speed > Increase or decrease the power rate manually.Power > Increase or decrease the power rate manually.Camera > Enable the camera and the camera shot will be shown on the panel.You can enable/disable different parts of the machine. ![]() You can use the control panel which is circled in red to control the laser head’s position.Maintenance and repair will enter the MAINTAIN page, mainly for hardware switch and signal display, it is highly recommended to read the subsequent maintenance chapter or through the customer service guide before operation. Mechanical switch for maintenance, repair, and troubleshooting Manual start point setting: The start point is the zero position (0,0), click > Move the laser head to the appropriate position through the control panel > OK. The starting point can be set manually before work, and the power rate and speed rate can be set instantly during work. When you click a Work/File, the actual position of the image in the working area, the estimated working time, and the real-time power and speed setting multiplier will be displayed on the screen. There is no limit to the number of files that can be viewed on a USB flash drive. Files read from USB flash drives : USB flash drives > specific tasks. The machine can record up to 15 tasks sent by the software Beam Studio, and recent-01.fc will be the latest task sent.Ģ. Tasks sent to the machine from Beam Studio : “Built-in Memory” > “Recent” > specific tasks. There are two ways to transfer the working tasks, either by Beam Studio software or by USB flash drive, both of which can be used to find and use the files from "START" after transfer.ġ. Most of the time, clicking on the status bar will return to the home page, during carving will reorganize the page. The status bar shows the connection status of the machine, whether it is connected to Beam Air or not as well as the temperature, water flow and door opening/closing status when the work is in progress. This chapter will introduce the machine interface and the seven key functions. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |